{overleaf template gallery}Community articles — Recent

In this work, we investigate the STO as a detector with in-plane geometry using field modulation Spin Torque ferromagnetic resonance (FM-STFMR), during which microwave signal is injected into the device and output response is measured in terms of RMS voltage across lock-in amplifier. The microwave signal injected externally to STO, efficiently synchronizes signal at two times the frequency of free oscillation of the nanomagnet (f0). The synchronization efficiently enhances signal sensitivity at 2f0 which opens other potential for development of spintronic devices. The effect of synchronization in STO under applied input RF power follows a consistent decrease in sensitivity with increasing power. Better synchronization at 2f0 is noticed above threshold current and shows good agreement with the results of numerical simulations.

Microcontrollers.

Resume of Yogesh Patil

En esta práctica utilizamos un láser con el cual medimos los diferentes ángulos resultantes que este hacía cuando era reflejado o refractado con diferentes ángulos de incidencia, con la finalidad de comprobar las leyes de reflexión y refracción de la luz.

An attempt to create a compact introduction to Overleaf and LaTeX in general. Topics and examples are tailored to meet the needs of The Hudson School. This is a work in progress. The document works well as a PDF and most examples are included verbatim.

An indoor positioning system relying on time difference of arrival measurements of ultrasonic pings from fixed transmitters. Code available at https://github.com/YingVictor/ultrasonic-positioning

Considering the growing impact of ideas nowadays, via quaternary sector, the plagiarism detection has become constant in texts, songs, as well as source codes. This work proposes the creation of the tool \nameOfProgram \ for plagiarism detection in simple texts with GNU GPL license. \nameOfProgram \ was designed to allow your extension for plagiarism detection in source codes. The tool was tested and results are presented in this paper.

Este ejemplo hace uso de los paquetes circuitikz y siunitx para dibujar el esquema de un amplificador de 18W a base de transistores bipolares y MOSFET. El circuito fue tomado de http://www.circuitstoday.com/mosfet-amplifier-circuits.

En esta práctica se utilizarán conocimientos de cinemática para encontrar el valor de la aceleración gravitacional, por medio de dos experimentos diferentes, uno que involucra la caída libre y el otro involucra un péndulo, además, se estimará la confianza y validez de los resultados.